TGR6000 AIM-TTI射頻信號發生器6GHz

產品/服務：TGR6000 AIM-TTI射頻信號發生器6GHz
型號：TGR6000
品牌：英國 aim-tti
單價：面議
更新日期：2024-09-19
有效期至：長期有效
瀏覽次數：2168

產品簡介

AIM-TTI射頻信號發生器6GHzTGR6000：The TGR6000 is a low-cost 6GHz signal generator intended for CW (carrier wave) applications where modulation is not required....

產品詳細介紹

AIM-TTI射頻信號發生器6GHz
AIM-TTI射頻信號發生器6GHz
AIM-TTI射頻信號發生器6GHz
TGR6000信號發生器,英國tti TGR6000：
6GHz RF Signal Generator

10MHz to 6000MHz frequency range
10Hz setability, +/-1ppm frequency stability
Locking to external frequency standard
-110dBm to +7dBm amplitude, 0.1dB steps
Fast stepping sweep with dwell times down to 10ms
List sweep of up to 1000 points of amplitude vs frequency
User compensation tables for specific test set-ups
Storage for 12 generator set-ups and 16 sweep lists
Compact half-rack 2U casing uses minimum bench space
Full remote control through RS232, USB, LAN and GPIB
Significantly lower cost than other 6GHz generators

TGR6000信號發生器,英國tti TGR6000：
Aim-TTi TGR6000 6GHz RF Signal Generator

The TGR6000 is a low-cost 6GHz signal generator intended for CW (carrier wave) applications where modulation is not required. Low phase noise is matched by low leakage, low residual FM and spurii. The internal timebase has a 1ppm stability, and an external frequency reference can be used. Sophisticated sweep functions enable the frequency and/or amplitude to be swept over the full range of each in a single sweep.

0MHz to 6000MHz frequency range
10Hz setability, +/-1ppm frequency stability
Locking to external frequency standard
-110dBm to +7dBm amplitude, 0.1dB steps
Fast stepping sweep with dwell times down to 10ms
List sweep of up to 1000 points of amplitude vs frequency
User compensation tables for specific test set-ups
Storage for 12 generator set-ups and 16 sweep lists
Compact half-rack 2U casing uses minimum bench space
Full remote control through RS232, USB, LAN and GPIB
Significantly lower cost than other 6GHz generators

TGR6000信號發生器,英國tti TGR6000：

Technical specification
Frequency
Frequency Range	10MHz to 6000MHz
Setting Resolution	10Hz by direct keyboard entry, or in user-set increments of 10Hz to 999?999MHz by rotary control or increment–decrement keys
Phase Noise	500MHz Carrier: <-110dBc/Hz @ 20kHz offset; <-120dBc/Hz @ 100kHz
	3GHz Carrier: <-95dBc/Hz @ 20kHz offset; <-110dBc/Hz @ 100kHz offset
	6GHz Carrier: <-89dBc/Hz @ 20kHz offset; <-104dBc/Hz @ 100kHz offset
Residual FM	Equivalent peak deviation for 300Hz to 3.4kHz B/W: 12Hz at 500MHz carrier
Settling Time	<8ms to settle within 100Hz or 0.1ppm of final frequency, if greater
Reference Frequency	Internal or External (via rear panel BNC)
Internal Accuracy	+/- 1 ppm over 15°C to 30°C; +/- 2 ppm over 5°C to 40°C
Internal Stability	< +/-1ppm/year ageing
Internal Ref. Out	10MHz from 50 Ohms, amplitude 2V pk-pk into 50 Ohms
External Ref In	10MHz into 50 Ohms, amplitude 2V pk-pk to 5V pk-pk
Output Level
Level Range	–110dBm to +7dBm (0.1μV to 500mV into 50 Ohms)
Setting Resolution	0.1dB (or 0.01μV to 1mV) by direct keyboard entry, or in user-set increments of 0.1dB to 100dB (or 0.01μV to 100mV)
Accuracy	Better than ± 2dBm
Harmonics	<-25dBc at +7dBm. <-30dBc@levels <=0dBm 30 to 6000MHz, <-25dBc@levels <=0dBm 10 to 30MHz
Sub-Harmonics	<3000MHz : None. >3000MHz :<–40dBc (typ) @ +7dBm
Non-Harmonic Spurii	<–50dBc >10kHz offset 10 to 3000MHz,10kHz offset 3000MHz to 6000MHz
Output Connector	Type N
Sweep	Frequency and amplitude sweep
Step Sweep	Step frequency and/or amplitude according to a formula over a specified number of points
Dwell Time	Individually programmable 0.01 to 10.000sec per step
Max Points	1000
Sweep Run	Continuous or single. Sweep up or down
Step Spacing	Linear or logarithmic
Sweep Triggering	Manual, Ext. signal, timed (0.1 – 999.9sec) or via remote interface
Sync Signal	Output Stable) available during dwell time. Programmable as high or low
List Sweep	As for Step Sweep except that a user defined table of frequency, amplitude and dwell time values defines the steps. The table can be created within the instrument or downloaded via the remote interfaces
Max Points	1000
List Storage	Up to 16 Sweep Lists can be stored permanently within the instrument
Point Trigger	Each point in a sweep (step or list) can be subject to a trigger event rather than a dwell time. Trigger by Manual, Ext. signal or via remote interface
Trim	(User Level Compensation Tables)
Function	A table of frequency/gain pairs allows the user to modify the generator output level with respect to frequency to calibrate an entire test set up or improve the calibration of the generator alone
Max Points	100
Interfaces	Full digital remote control through the RS232, USB, LAN and GPIB interfaces
RS-232	9-pin D connector. Variable Baud rate 1200 and 115200 Baud
USB	USB 2.0 connection. Operates as a virtual COM port
GPIB (IEEE-488)	Conforming with IEEE488.1 and IEEE488.2
LAN (Ethernet)	Standard 10/100 base-T hardware connection. ICMP and TCP/IP Protocol
General
Size and Weight	2U (86.5mm) height; half-rack (213mm) width; 350mm long. 3.65 kg. (8 lb)
Power	110-240VAC ±10% 50/60Hz; 100-120VAC ±10% 400Hz; 60VA max
Approvals	Complies with EN 61010-1 (Safety) and EN61326 (EMC)

隨附

Operating manual, driver software, power lead

TGR6000信號發生器,英國tti TGR6000：

zui大頻率	6000MHz
	zui小頻率	10 兆赫
	分辨率	0.1 dB
	掃描	線性，對數
	接口類型	GPIB，LAN，RS232，USB
	尺寸	350 x 213.5 x 86.5mm
	zui高工作溫度	+40°C
	型號（P）	TGR 6000
	高度	86.5mm
	插頭類型	Type C - European Plug, Type G - British 3-pin
	重量	3.65kg
	zui低工作溫度	+5°C
	長度	350mm
	數據輸入	鍵盤
	輸入	交流輸入，參考輸入，觸發輸入
	寬度	213.5mm
	顯示器類型	20個字符′4行

如果您覺得“TGR6000 AIM-TTI射頻信號發生器6GHz”描述資料不夠齊全，請聯系我們獲取詳細資料。(聯系時請告訴我從給覽網看到的，我們將給您最大優惠！)
本頁鏈接：http://lgsztm.com/com_sdongjin/sell/itemid-7268762.html
已經有2168位訪客查看了本頁.

產品咨詢

* 詢價標題：
快捷提問：	(不用打字 “快捷提問”幫您忙！)
* 主要內容：	我希望在日前回復
公司名：
*聯系人：
*聯系電話：
電子郵箱：
QQ ：
* 驗證碼：

詢價標題
聯系人
電話
主要內容
驗證碼

TGR6000 AIM-TTI射頻信號發生器6GHz

AIM-TTI射頻信號發生器6GHzTGR6000：The TGR6000 is a low-cost 6GHz signal generator intended for CW (carrier wave) applications where modulation is not required....

相關產品推薦

相關技術文章