Zy6058漏電起痕試驗機
Tracking testing machine
漏電起痕試驗機采用矩形鉑電，兩對試樣的作用力分別為1.0N±0.05N.施加電壓在100～600V（48～60Hz）之間可調，短路電流在1.0±0.1A時，電壓下降應不超過10%，當試驗回路中，短路漏電電流等于或大于0. 時，時間維持2秒鐘，繼電器動作，切斷電流，指示試品不合格。滴液裝置時間常數可調，控制滴液量大小44～50滴/cm3和滴液時間間隔30±5秒。
Tracking tester adopts rectangle platinum electrode, the force of specimen were 1.0 between N + / - 0.05 n.
imposed in 100 ~ 600 v voltage adjustable between (48 ~ 60 hz), short circuit current in 1.0 + / - 0.1 A,
voltage dro should be no more than 10%, when the test loop, the short circuit when the leakage current is
equal to or greater than 0.5 time keep 2 seconds, relay action, to cut off the current, the sample (s)
indicating not qualified. Time constant drip device is adjustable, accurate control fluid volume size 44 ~ 50
drops/cm3 and drops the time interval of 30 + / - 5 seconds.
符合GB/T4207試驗標準。In line with the GB/T4207 test standard.
一、電：截面積為2mm×5mm兩個矩形鉑電。一端邊緣為30°斜面。
二、表面作用力：1.0±0.05N
三、試驗電壓電壓：100~600V
四、zui大試驗電流：3A
五、兩電距離：4.0mm
六、滴液裝置：滴液時間間隔可任意設定
七、試驗箱容積：0.5M3 ，深x寬x高：60 95x 90cm
八、外形尺寸：深x寬x高：61x 120 105cm
九、外箱材質：靜電烤漆和鏡面不銹鋼。根據客戶要求和業務談定情況而選定
A, electrode: two cross-sectional area is 2 mm x 5 mm rectangular platinum electrode. Side edge to 30 °
incline.
Second, the surface forces: 1.0 + / - 0.05 N
3, test voltage, voltage: 100 ~ 600 v
Four, the biggest test current: 3 a
Five, two electrode distance: 4.0 mm
Six, drip device: drip time interval can be set freely
Seven, the test chamber volume: 0.5 M3, deep x width x height: 60 x 95 x 95 cm
Eight, overall dimensions: deep x width x height: 61 x 120 x 105 cm
Nine, carton material: electrostatic painting and mirror stainless steel. According to customer requirements
and business conditions and the selected my briefcase
本頁產品地址：http://lgsztm.com/sell/show-4371642.html
免責聲明：以上所展示的[ZY6058 漏電起痕試驗機]信息由會員[東莞中諾臺灣質檢儀器設備有限公司]自行提供，內容的真實性、準確性和合法性由發布會員負責。
